Telemetry :The Drive Battery Voltage - FUTABA 7PX User Manual

Telemetry :The Drive Battery Voltage

With an external power supply, one voltage of the batteries (drive battery, servo power sup-
ply battery, etc.) mounted separately in the chassis can be displayed at the transmitter. The
receiver S.BUS2 connector is used to connect the SBS-01V sensor and the battery.
* A drive battery sensor must be installed in the model car. Install and connect the sensor in accordance
with the sensor instruction manual.
Telemetry
Sets the limiter voltage
(Voltage that sounds an alarm)
Alarm and Vibrator function setup
1
(Limit adjustment)
Tap the [Limit]. Value input buttons appear on the screen.
Use the [+] or [-] button to adjust the limit voltage.
2
(Alarm function setup)
Tap the [Alarm] type and select [Inhibit], [Buzzer]or [Voice].
"Inhibit" :No audible alarm
"Buzzer" :Audible alarm
"Voice" :Voice alarm
3
(Vibrator function setup)
Tap the [Vibrator] type and select [Inhibit], [Type 1], [Type 2],
or [Type 3].
"Inhibit" :No active vibration
"Type1" :Continuous vibration
"Type2" :Intermittent vibration for a long time
"Tyoe3" :Intermittent vibration for a short time
4
(Speech function setup)
Tap the "Voice" (ON) or (OFF) to select ON / OFF.
"OFF" :No voice guide
"ON" :Information loaded by voice
5
When fi nished, return to the Telemetry screen by pressing the HOME button.
1M23N32602_7PX_E.indb 155
Current drive battery voltage
The minimum and maximum when
powering ON are shown.
Alarm/vibrator ON/OFF and type
setting (The arrow indicates that an
alarm is generated when the power
supply voltage drops below the set
value.)
The Speech function (ON/OFF)
Telemetry
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Setting
- Tap alarm type.
Inhibit/ Buzzer/ Voice
Setting
- Tap Vibrator type.
TInhibit/ Type 1/ Type 2/ Type 3
Setting
- Tap (ON) / (OFF).
*The voice guide loading inter-
val is set by sensor menu.
2017/08/02
155
14:17:41