Changing Receiver Modes; Sleep Mode - Javad TRIUMPH-1 Operator's Manual

5.6. Changing Receiver Modes

The receiver has the following two modes:
• Normal Mode – the standard surveying mode.
• Sleep Mode – used to stop recording data, but keeps the receiver powered on "standby".

5.6.1. Sleep Mode

In sleep mode, the power board and Bluetooth module will continue to draw power from the
batteries, causing the batteries to drain over time. Sleep mode is the normal "off" state of the
receiver.
1. Connect your receiver and computer, as described in "Connecting the Receiver and a
Computer" on page 37.
2. Turn on your receiver.
3. Start TriVu
information about Manual Mode):
4. To put receiver into Sleep Mode send set,/par/sleep,on command. If a character
is received on one of the serial ports while the receiver is in sleep mode, power will be
immediately switched on. Also, the wake-up time option is available for this parameter.
For example, the command set,/par/sleep,on:2d23h3m55s instructs the
receiver to go into sleep mode and then wake up on next Monday (2d) at 23h3m55s GPS
time.
See GREIS for detailed information about sleep mode.
www.javad.com
File Manual Mode (see TriVu Software Manual mode for detailed
Receiver and File Maintenance
Changing Receiver Modes
Sleep Mode
89