Turning On/Off The Receiver; Connecting The Receiver And A Computer - Javad TRIUMPH-1 Operator's Manual

• Plug the Receiver-to-SAE cable's 5-pin connector into the power port of the receiver
(labeled PWR).
• Connect the opposite end of this cable with the battery charger's SAE connector.
• Plug the appropriate end of the power supply-to-outlet cable into the battery charger.
• Plug the other end of this cable into an AC outlet.
• Turn off the receiver by pressing and holding the power key for more than one and less
than four seconds.
• Leave overnight.

2.6.1. Turning On/Off the Receiver

To turn ON the receiver, press and hold the power button until the LEDs briefly flash. To turn
OFF the receiver, press and hold the power key for more than one and less than four seconds
(until both the SAT and the REC LEDs are off).
This delay (about 1 second) will prevent the receiver from being turned off by mistake.

2.7. Connecting the Receiver and a Computer

JAVAD GNSS TriVU software provides an interface for various configuration, monitoring, and
management functions for the receiver.
To configure, manage files, or maintain the receiver, connect the receiver and a computer using
one of the following methods and start TriVU:
• a Bluetooth®-enabled external device (computer/controller)
• an RS232 cable and a computer/controller
• a USB cable and a computer/controller with the JAVAD GNSS USB driver installed
Once you have established a connection between the receiver and the computer/controller, you
will be able to configure the receiver and its components, send commands to the receiver,
download files from the receiver's memory; as well as, upload new firmware, upload an OAF,
and upload configuration files to a receiver, using TriVU.
www.javad.com
Pre-survey Preparation
Connecting the Receiver and a Computer
Turning On/Off the Receiver
37