Configuring The Internal/External Uhf Modem/Gsm Module - Javad TRIUMPH-1 Operator's Manual

Configuration

Configuring the Internal/External UHF Modem/GSM Module

• Configure one receiver as a Base station and the other receiver as a Rover. See
"Configuring the Receiver" on page 56.
• Set up the Base receiver over a known point to begin collecting static observation data. Set
up the Rover receiver to begin collecting static or kinematic observation data. See
"Receiver Setup" on page 71 for more information.
3.1. Configuring the Internal/External UHF Modem/GSM
Module
ModemVU is JAVAD GNSS's configuration utility for modems embedded in JAVAD GNSS
receivers. ModemVU provides the following functions:
• Connecting a computer to an integrated UHF modem via a serial port or Bluetooth®
wireless technology.
• Displaying information about the radio modem installed in the receiver.
• Programming the radio modem's settings.
• Loading the new modem firmware.
See the ModemVU Software Manual available on the JAVAD GNSS website for details on
configuring the receiver with an internal UHF modem and/or GSM radio modem, or an external
UHF modem.
For JAVAD GNSS receiver, the integrated UHF radio modem provides TX/RX communications
between a Base and Rover. To configure an UHF modem/GSM module, have the following
ready:
• Computer running Windows®;
• ModemVU Software installed on the computer;
• A serial cable;
1. Connect the computer and receiver/HPT 435. Turn on the receiver/HPT 435.
2. Start ModemVU.
44
www.javad.com