Charging The Batteries; Power Supply Requirements - Javad TRIUMPH-1 Operator's Manual

2.4. Charging the Batteries

C : Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according
AUTION
to the instructions.
Before beginning to work, fully charge the batteries for maximum operating time. An
approximately 6-hour charge cycle will fully charge the batteries; the batteries will charge
simultaneously. The batteries can not be overcharged.
Note:
The batteries are shipped from the factory with 40% of power. Fully charge the batteries before
surveying.
The Li-Ion batteries used in the battery packs should run at no less than 80% capacity after 500
charging cycles. These batteries do not need to be drained before recharging.
D : N
ANGER EVER ATTEMPT TO OPEN THE CASING OF THE DETACHABLE BATTERIES
BATTERIES CAN BE DANGEROUS IF MISHANDLED
D : D
ANGER O NOT INCINERATE OR HEAT BATTERY PACK ABOVE
DEGREES CELSIUS
.
EXPLOSION
D : T
ANGER HE BATTERIES
SUCH AS SUNSHINE
Warning: Do not attempt to open the battery pack.
Warning: Do not disassemble the battery pack.
Warning: Do not charge in conditions different than specified.
Warning: Do not use other than the specified battery charger.
Warning: Do not short circuit the battery pack.
Warning: Do not crush or modify the battery pack.

2.4.1. Power supply requirements

The socket-outlet shall be installed near the equipment and shall be easily accessible.
A single external power supply with 5 pin ODU connector or SAE connector is necessary to
operate TRIUMPH-1. If external power supply has only SAE connector, Receiver-to-SAE power
cable shall be used. The external power supply needs to be Listed for US and Certified for EU
www.javad.com
). E
XCESSIVE HEAT CAN CAUSE SERIOUS DAMAGE AND POSSIBLE
(
OR BATTERIES INSTALLED
, .
FIRE OR THE LIKE
!
212
DEGREES FAHRENHEIT
)
SHALL NOT BE EXPOSED TO EXCESSIVE HEAT
Pre-survey Preparation
Charging the Batteries
Power supply requirements
! L -I
ITHIUM ON
(100
31