Javad TRIUMPH-1 Operator's Manual page 53

Parameter
TCPCL port
4. Set up the GSM module making settings in the appropriate subtabs according selected
mode.
5. After all settings click Apply, then click File Disconnect.
6. If needed, launch TriVU and set up the receiver to run as an RTK Base station.
www.javad.com
Specify the type of incoming data to accept on the TCPCL receiver port:
•None means that the port will ignore any incoming data.
•Command - port is in command mode. Being in this mode, the receiver's port
recognizes commands sent by the user.
•Echo - echo mode.
•RTCM 2.x - RTCM 2.x input mode.
•RTCM 3.x - RTCM 3.x input mode.
•CMR - CMR/CMR+ input mode. For more information on CMR format, please refer
to ftp://ftp.trimble.com/pub/survey/cmr.
•JPS - JPS input mode. In this mode receiver is capable to recognize both standard and
non-standard JPS messages.
Figure 3-8. Service tab
Configuring the Internal/External UHF Modem/GSM Module
Configuring the GSM module for Internet access
Value
Configuration
53