How To Image An Exposure Test Page - AGFA SelectSet Avantra User Manual

Drum laser imagesetter
Table of Contents

Advertisement

How to Image an Exposure Test Page

1. Select a test page:
When selecting an increment value, follow these guidelines:
• An increment value of 10 is useful when you are not sure what the
exposure setting should be. (When evaluating a new type of media,
for example.) The higher value yields the widest range of exposures
on the test image.
• Use the lower values (5 or 1) when you have a better idea what the
exposure setting should be.
• In tests run with higher increment values, the lowest and highest
exposures may be far out of range. In this case, determine which
exposure setting is closest to the results you need, set that as the
exposure, then run the test again using a smaller increment value.
• Expect each resolution to have a unique optimum exposure.
5–6 • SelectSet Avantra User Guide
Test Page
Select test:
4 dpi's, 1, 5, or 10
1200 dpi, 1, 5, or 10
1800 dpi, 1, 5, or 10
2400 dpi, 1, 5, or 10
3600 dpi, 1, 5, or 10
4 dpi's
1
2. Image the page:
Press Accept to begin the
test page or...
...press Abort to cancel.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SelectSet Avantra and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF