Stdby Replenishment; Manual Replenishment - AGFA SelectSet Avantra User Manual

STDBY Replenishment

STDBY replenishment is released at regular intervals to compensate
for the evaporation and oxidation of developer and fixer. The replenish-
ment takes place when the processor is in run mode (switched on), and
in standby mode (switched off).
Because the amount of chemicals pumped into the tanks is always 100
cc., the interval between each pulse is automatically calculated as 100
cc. x 24 hours, and the result is divided by the preset value:
100 cc. × 24 hours*
Interval time = _________________________
Preset Stdby Repl. Value
If the processor is on for periods of less than 24 hours, multiply the
required Standby Repl. value by 24 hours and then divide the result
by the number of working hours to obtain the new preset Standby
Repl. value:
Required Stdby. Repl. Value × 24 Hours
Preset Stdby. Repl. Value = ______________________________
Working Hours

Manual Replenishment

Press the MAN REPL key to release replenisher manually. Each time
you press the key, you release 100 cc. of developer and fixer. You may
use this key to adjust the level of developer and fixer in the tanks, or
to restore the balance or activity in the tanks in case of insufficient
replenishment.
Tips and Tricks • B–9