Processor Maintenance; Daily Maintenance - AGFA SelectSet Avantra User Manual

Processor Maintenance

This section describes daily, weekly, and monthly maintenance rou-
tines. Proper maintenance of your processor is essential to getting the
best possible photographic results from your imaging system.
Follow a regular maintenance program. A thorough cleaning at least
once a month is strongly recommended.
The frequency of your maintenance program may vary. If your shop
runs multiple shifts or high volumes of media, repeat these procedures
more frequently.
WARNING:
Always wear adequate protection. Wear rubber gloves,
a rubber apron, and goggles when you clean the pro-
cessor.

Daily Maintenance

Follow this procedure every day before you process any media:
• Check the replenishment containers.
Refill containers with fresh chemistry when the level is two inches
(5 cm) from the bottom of the container.
• Check and empty waste containers (if installed).
When depleted chemistry is four inches (10 cm) from the top of the
container, dispose of chemistry and install new waste containers.
Note: Always dispose of developer, fixer, and wash
water according to local regulations.
• Top off chemistry every morning.
Remove main cover and manually replenish until both developer
and fixer are topped off.
Avantra 20/25 OLP: Processor Operation • 9–23