AGFA SelectSet Avantra User Manual page 114

57 Processor Error
The on-line processor is reporting an Input Jam, an Exit
Jam, or a Motor Overload error.
Clear the error and check the on-line processor control
panel. For more information, see the section Processor
Status and Error Messages in chapter 9.
The imagesetter will abort the current job, and will not
image another job or advance media until the processor
error is cleared.
58 No Processor Communication
The on-line processor is not communicating with the im-
agesetter.
Check the processor to make sure that it is on.
59 Processor Top Door Open
The top door in the on-line processor is open. This door
needs to be open when you use the processor off-line. If
this message appears and you are not currently using the
processor off-line, check to make sure that the door is se-
curely closed.
The imagesetter will finish the current job, but will not
image another job or advance media until the door is
closed. After you close the door, the imagesetter auto-
matically resumes operation.
Diagnostics and Error Messages • 6–13