AGFA SelectSet Avantra User Manual page 107

27 Processor Alarm Signal
The optional on-line media processor is reporting an
alarm. This message appears as an overlay on the screen
that is currently displayed on the imagesetter control
panel.
The imagesetter will finish the current job, but will not
image another job or advance media until you correct the
error at the processor.
Check the alarm signal LEDs on the processor control
panel. For more information, see the section Alarm Signals
in chapter 9.
After you correct the error at the processor, the imageset-
ter automatically resumes operation.
28 Hardware Error
Reset. If the error persists, call for service.
31 Input Side Punch Jam
Reset and retry the command. If the error persists, call for
service.
32 Carriage Position Error
The system detected a problem with the carriage while
imaging.
Reset. If the error persists, call for service.
6–6 • SelectSet Avantra User Guide