Overriding Error 44: Cut Not Allowed
When you press Cut in the Utilities Screen, the imagesetter checks to
make sure that at least 5" (12.7 cm) has been fed past the cutter. Mes-
sage 44, Cut Not Allowed, appears if not enough media has been fed.
You can clear this message and get the imagesetter to make the cut
without advancing media. Follow these steps:
Step 1.
Go to the Utilities Screen.
Step 2.
Press Cut then Accept.
Step 3.
When message 44 appears, press Pause. You return to the
Utilities Screen.
Step 4.
Immediately press Cut then Accept again.
Note: Use this override only if you are absolutely
sure that at least 5" (12.7 cm) of media is past the
cutter. If the cut produces a sliver of media less
than 5" long, you may have trouble removing it.
6–16 • SelectSet Avantra User Guide
Need help?
Do you have a question about the SelectSet Avantra and is the answer not in the manual?