Other Functions; Sound; Pan Light - AGFA SelectSet Avantra User Manual

Other Functions

Sound

Press SOUND to switch the audible "beep" on or off.
The "beep" sounds when the trailing edge of the material being pro-
cessed clears the film input sensor. This signal also indicates that you
can insert the next piece of media to be processed.

Pan Light

Controls the brightness of the LED display. There are two modes: max-
imum and adjustable. In the maximum mode, the LED level is set to
maximum light intensity. The adjustable mode allows you to change
the intensity between the maximum and minimum (turned off).
Note: Use the minimum setting for Panchromatic ma-
terials in darkroom environment.
Follow this procedure to adjust the LED intensity level:
Step 1: Press PAN LIGHT and PRESET.
Step 2: Press plus (+) or minus (-).
Step 3: When you reach the LED intensity you want on the control
panel, press Enter.
After you preset the adjustable level, you can switch between maxi-
mum and the adjusted level by pressing PAN LIGHT several times.
Avantra 20/25 OLP: Processor Operation • 9–17