Function 3: Extension Programming; Function 31: Extension Definition And Routing - ESI IP 200 Installation Manual

IP Series Installation Manual

Function 3: Extension programming

This section provides programming for extensions and department groups.
Important: Where any gray shading ( ) appears in an example, it represents values either
unavailable to the function or unused in the particular example.

Function 31: Extension definition and routing

Extensions can be either of the following:
• IP Feature Phone extensions (IP PHONE in the chart below and succeeding charts) — These are
numbered with extensions between 100 and 195, inclusive, and may be either local phones or
remote phones.
• Analog ports (ANALOG in the same charts) — These are numbered with extensions between 200
and 229, inclusive, and are dependent on the port card to which they are attached — i.e., the
first 303 port card will host extensions 200, 201 and 202, while the second 303 hosts exten-
sions 203, 204 and 205 — and so on.
Below is an example of the portion of a completed programming worksheet (Appendix II).
Ext
0
100
101
102
109
200
201
Note: Extension 100 defaults as OPR (when a user dials 0) and is an example of system default.
Local IP Feature Phones
Below is an example of the portion of a completed programming worksheet (Appendix II) for local
IP Feature Phones.
1. 2.
Ext Type
0
100 Local IP
105 Local IP
113 Local IP
109 Local IP
Note: Extension 100 defaults as OPR (when a user dials 0) and is an example of system default.
Type Name
groups
Operator
Local IP Jane
Remote IP Roger
Remote IP Sally
Local IP Dean
Analog Roger 2
Fax Fax
3. 4.
Name CO
Operator
Jane 9
Carl 9
Maria 9,8
Dean 9,8
Function 3: Extension programming
Line CF day CF
night
X100 X100
9 MB100 X105
9 MB101 MB101
9,8 MB102 MB102
9,8 MB109 MB109
9 MB110 MB106
5. 6.
CF day CF night
X100 X100
MB100 X105
MB105 MB105
MB113 MB100
MB109 MB109
Pg zone Ext
X100
0,1,2
0, 2
7. 8.
Pg zone Ext
X100
0, 1, 2
0, 2
0, 1
0, 2
F.1