ESI IP 200 Installation Manual page 47

IP Series Installation Manual
Programming a circuit
To program a circuit, select the appropriate DSS key and press the # key to confirm. You can select
from the first set of 16 COs, and then press the scroll keys to select from the remaining eight CO
lines on the first DLC (T1). Scrolling again will allow you to select the 16 COs on a second DLC (T1) if
one is installed, and scrolling again will allow you to select from the 8 remaining COs. If there is
only one DLC (T1) installed, then scrolling will return you to the first 16 COs.
PC3 T1 13-36
CO22 CIRCUIT 10>
After selecting the COs to program, use the scroll keys to select the new level of gain or loss in dB.
Press # to confirm. Select additional circuits to adjust and program as above.
RECEIVE VOLUME
LINE COMP -28DB>
Range: -28 dB to 6 dB (lowest to highest gain, respectively).
Default: -6 dB.
Function 234: PRI receive volume
Many variables can affect the volume of PRI lines. Different volume levels may be required when
connecting a DLC configured for PRI depending on the signal level of the PRI line. The volume level
can be adjusted by increasing or decreasing the setting in this function. By default, the setting is –6
dB; changes to the setting are in 2-dB increments.
Example: If calls received at the extension have low volume levels, the pad level for that PRI
circuit can be adjusted to increase the volume. Select the circuit to adjust by pressing
the appropriate DSS key and press # to confirm. Use the scroll keys to select the ap-
propriate dB level and press # to confirm.
Programming a circuit
To program a circuit, select the appropriate DSS key and press the # key to confirm. You can select
from the first set of 16 COs, and then press the scroll keys to select the from the remaining seven
CO lines on the first DLC (PRI). Scrolling again will allow you to select the 16 COs on a second DLC
(PRI) if one is installed, and scrolling again will allow you to select from the seven remaining COs. If
there is only one DLC (PRI) installed, then scrolling will return you to the first 16 COs.
PC3 T1 13-36
CO22 CIRCUIT 10>
After selecting the COs to program, use the scroll keys to select the new level of gain or loss in dB.
Press # to confirm. Select additional circuits to adjust and program as above.
RECEIVE VOLUME
LINE COMP -28DB>
Range: -28 dB to 6 dB (lowest to highest gain, respectively).
Default: -6 dB.
Function 2: CO lines
E.15