ESI IP 200 Installation Manual page 91

IP Series Installation Manual
Enter the remote-access IP address for the location's IP PBX. This is the public IP address or private
WAN address used for remote access to the location's IP PBX. Enter the address in dotted-quad
notation, using the # key as the dot between the octets. Press # again when finished.
701 HOU RMT IP
_
Enter the UDP port number assigned to the location's IP PBX. Press # to confirm (and complete the
Function 832 entries).
701 HOU PBX UDP
__001
Function 833: Deleting an Esi-Link location
This function is used to delete previously entered information about Esi-Link sites. Enter the
location number to be deleted and press # to confirm.
ESI-LINK LOC
NUMBER? _
When prompted to confirm deletion, press 1. To cancel deletion, press any other key.
1 TO DEL LOC
701 HOUSTON
Function 834: Programming Esi-Link publish
Each Esi-Link-enabled IP PBX can "publish" (or transmit) lamp appearance updates to the other
Esi-Link locations. A combination of up to 30 extensions and mailboxes can be programmed to
be published. When programmed on a programmable feature key at another Esi-Link location,
lamp appearance for numbers on the Esi-Link publish list will automatically update.
Use the up and down arrow keys to scroll through the list. An entry can be programmed by entering
an extension number, CO number, or department group number. A mail box can be entered by
pressing the voice mail key followed by the mailbox number. Press # to confirm the entry.
To remove an entry from the list, use the up and down arrow keys to scroll to that entry and press
HOLD to delete, or enter a new number or mailbox.
Function 8: IP PBX programming
K.5