ESI IP 200 Installation Manual page 34

Function 2: CO lines
Choose CO lines to program
During this step, you use the 16 programmable keys to represent CO lines. Select lines to be pro-
grammed by pressing one or more of the programmable keys. Press the scroll keys to "page" to
lines 17–32, 33–48, 49–64 and 65–66. The display will indicate "
etc., to indicate which CO lines the programmable keys currently represent.
Select the line keys to be programmed alike by pressing one or more programmable keys (a selected
key's LED grows green), and then pressing # to confirm. After programming the steps outlined in
the discussion for these keys (programmed keys' LEDs will glow green), select additional line keys
to program alike, until all required lines have been programmed (and their keys' LEDs glow green.)
T1 lines: special note
If a DLC configured for T1 is installed, an extra programming step will be required to select the line type.
When a programmable key is pressed to select it for programming as described above, the display
will show " "; continuing to press the same key will cycle the display through the following:
LOOP
• & /
E M DNIS DID
• &
E M
•
LOOP START
•
GROUND START
Once you select the correct type, continue to additional lines and proceed with the programming.
PRI: special note
If you are programming channels on a DLC configured for PRI, you will not be able to select the line
key for channel 24; this is a dedicated channel of the span for signaling purposes. However, be-
cause channel 24 will use a port, the next card in the system will still start at CO 25 if the DLC is the
first card in the system.
Naming the CO lines
During this step, you can name the CO lines you are programming. Each name can contain up to 10
alphanumeric characters. This step is optional.
If you press # during this step, the default names (e.g., Line 1, Line 2, etc.) will be retained.
If you select multiple CO lines to program, the name field will be left blank; you can either press # at
this point to keep all of the lines' default names or, by entering a name, assign the same name to
all selected CO lines.
If you want to change an already programmed name to the default value, press HOLD to delete the
name and then press # while the field is blank; this restores the default values for all selected lines.
If used in conjunction with Caller ID, this feature causes the Caller ID name to appear on the top
line, and the CO line name on the bottom line, for five seconds after someone answers a call on
that line. After that, a call timer appears on the top line's right side and, on the bottom line, the CO
line name is replaced by the usual lines-in-use display.
If Caller ID is not enabled, the CO name will appear on the top line of the display and the CO line
use indications will be on the bottom line.
Default: Line numbers.
E.2
IP Series Installation Manual
1 16," " 17
LINES TO LINES
32,"
TO