ESI IP 200 Installation Manual page 44

Function 2: CO lines
Programming ARS
1. Enable/disable ARS (default is DISABLED).
2. Select the ARS table to program (3–10).
3. Use the scroll key to select the line group.
4. Enter Other Common Carrier numbers.
5. Enter numbers for the table, separating each number by #.
Example: For "1-976," enter 1 9 7 6 #.
Note: Press MUTE/DND to insert a "wild card" digit. The Hold key will delete an entry.
Warning: Do not include the IP Series system's line access codes (9, 8 or 7) in this table.
The IP Series system will apply the numbers you enter to their most significant digit.
Examples: Entering 1 5 0 5 into the table tells the system to place all "1+" calls to area
code 505 to the line group and Other Common Carrier listed. Entering
1 5 0 5 4 4 5 8 7 8 7 into the table tells the system to place "1+" calls
specifically to (505) 445-8787 to the line group and Other Common Carrier
listed while other "1+505" calls will follow regular LD routing to line group 8.
After the last number, enter # # to end the list. Enter another list or press # to exit.
Note: Toll restriction, as set in Function 222, will be applied to calls before released.
Function 224: DID and DNIS translation table
A translation table is programmed to translate DID or DNIS routing numbers to the corresponding ID
(ID), mailbox (MB) extension (EXT) or department with both day and night destinations. The IP
Series system supports up to 4-digit DID and DNIS/ANI. Up to 300 numbers can be programmed
into the table (multiple numbers programmed to the same destinations). An entry for exceptions is
provided and can be programmed for an ID (ID), mailbox (MB) extension (EXT) or department.
Default: Operator.
DID/DNIS TABLE
DID/DNIS #:3352>
DID/DNIS TABLE
EXCEPTION:
To program the translation table:
1. Either enter the DNIS or DID number or use the scroll keys to select a previously programmed
number or exception.
Note: Pressing the right scroll key will start with a blank number field for input and continue
through all previously programmed numbers, ending with the exception entry (continuing
to scroll will start over the blank entry). Pressing the left scroll key will start with the
exception entry, continue in reverse order with previously programmed numbers and end
with the blank number entry (continuing to scroll will start over with the exception entry).
Note: Pressing HOLD will delete an entry.
2. Press the # key. The system will prompt you to enter a name for this DID line; the name will ap-
pear on the bottom line of the display of a station using the line.
E.12
>
IP Series Installation Manual