Function 24: Caller Id - ESI IP 200 Installation Manual

Function 2: CO lines

Function 24: Caller ID

This function activates the Caller ID capability in the IP Series system — provided that the customer
has ordered Caller ID service from the Telco. The system will display the caller's name (or other
designation such as "
OUT
number if the CO only provides a number).
Default: Disabled.
Esi-Dex and auto callback — This is accomplished by pressing REDIAL or the ESI-DEX key either
during message playback or after an Esi-Dex search. Caller ID numbers received from the CO are 10
digits long (and include the area codes for local calls). In auto callback, the IP Series system assumes
all calls are to be long distance and will automatically add a "1" prefix to the 10 digits to be dialed.
A table of local area codes can be programmed to indicate that calls to those area codes are to be
dialed as local calls. Select one of the following two types of local dialing for each area code entered:
• Local 7 — Local calls that can be dialed only as seven-digit numbers (the system strips the area
code before dialing and will not add a "1" prefix).
• Local 10 — Local calls that can be dialed only as 10-digit numbers (the system will not add a
"1" prefix).
If you have an area code that can be called as a long distance number (with a "1" prefix) and as a
local number (10 digits without a prefix), you must decide which case is the more prevalent and
then add to or exclude from the area codes exception list accordingly. Therefore, some of these
calls will have to be made manually.
Note: Since the Caller ID information is transmitted from the CO during the silence between the
first and second ring, enabling this feature will delay the answer of inbound calls until the
second ring.
E.16
- - ," etc.) for incoming calls or messages (or show the Caller ID
OF AREA
IP Series Installation Manual