Regulatory Information - ESI IP 200 Installation Manual

Hardware overview/installation IP Series Installation Manual

Regulatory information

United States of America
Registration
The CO line telephone numbers, FCC registration number, and ringer equivalence number (REN) of this equipment must be
provided to the telephone company before installation. (See below for FCC registration number and ringer equivalence number.)
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and — if
not installed and used in accordance with the instruction manual — may cause harmful interference to radio communica-
tions (in which case, the user will be required to correct the interference at his/her own expense).
FCC Part 68
Registration Number: 1T1USA-33727-MF-E
Ringer equivalence number (REN): 0.5
Dominion of Canada
Notice
The Industry Canada label identifies certified equipment. This certification means that the equipment meets telecommu-
nications network protective, operational and safety requirements as prescribed in the appropriate Technical Equipment
Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections at the power utility, telephone lines
and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important
in rural areas. Caution: Users should not attempt to make such connections themselves, but should contact the appropri-
ate electrical inspection authority, or electrician, as appropriate.
Ringer equivalence number (REN): 0.5
Notice
The ringer equivalence number (REN) assigned to each terminal device provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combina-
tion of devices subject only to the requirement that the sum of the RENs of all the devices does not exceed 5.
B.6