ESI IP 200 Installation Manual page 58

Function 3: Extension programming
8. Toll restriction — "YES" allows the user to place toll calls. If "NO," the user can make only either
non-toll calls or calls to numbers listed in the allow exception table.
9. System speed dial — "YES" allows the user to access and place system speed dial calls.
10. Auto-page — Lets the user turn auto-page (defined below) on or off at his/her station.
Note: This feature is used in conjunction with the directory names recorded in Function 62 and
is not active until a directory name is recorded for the extension.
If the station user has his/her mailbox set to answer with personal greeting 3 and a caller
presses 3 to page that user, this feature automatically pages the station user in the page zones
entered in Function 31. If no page zone is entered, all Feature Phones on the system are paged.
Default: Disabled.
11. External forwarding — Allows the station user to enable the off-premises-"reach-me" feature
(the user can give, to callers who are forwarded to his/her voice mailbox, the option of trying to
reach him/her at another number). This requires a trunk-to-trunk transfer and will use two CO
lines for the length of the conversation. The user must set his/her mailbox to answer with per-
sonal greeting 2 and inform the caller to press 4 for this option. After the system dials the last
digit of the external forwarding number, it will begin to play a prompt saying, "You are receiving
a forwarded call. Press any key to accept." This prompt will play continuously for 30 seconds.
When DTMF is detected at the remote end, both trunks are connected. If no DTMF is detected,
the caller is forwarded to the user's voice mail.
Default: Disabled.
12. Forwarding to toll numbers — This feature is used in conjunction with external forwarding (see
previous item). When enabled, this feature lets the user program a long-distance number for
external forwarding.
Default: Disabled.
*
While the two trunks are connected, the system constantly monitors the lines for open loops. If it detects an open loop
on either line, it terminates both CO connections. Additionally, the system periodically will monitor for voice on the
connected COs. If it detects no voice traffic, it terminates both CO connections. Finally, if both COs are connected for a
programmable period (default is 60 minutes), the system will terminate the connection, regardless of the presence or
absence of activity.
F.10
*
IP Series Installation Manual