ESI IP 200 Installation Manual page 27

IP Series Installation Manual
Entering Installer programming mode
You may program from any Feature Phone in the system. To enter programming mode:
1. Press PROG/HELP. The normal station programming menu prompt will begin to play.
2. Press PARK to stop the prompt.
3. Enter the Installer password, followed by #.
4. Follow the system programming menu.
5. When finished, hang up.
Note: While in programming mode, the extension will be automatically placed in DND.
Note: The system will automatically exit programming mode after 10 minutes of inactivity.
Example: To enter programming mode, press PROG/HELP, PARK, 7 8 9 [or new Installer
password], #. To exit programming mode, hang up.
Accessing user station programming
Should a user forget his password or if an employee leaves the organization, this feature allows the
Installer or Administrator to enter a user's station programming and operate within it as if he were
the user. From the user's station, enter the Installer or Administrator password when the system
prompts for the user password.
Example: From station 105, entering 7 8 9 # or 4 5 6 # instead of the user password (1 0 5 #) will
enter the station's user programming. (Default passwords shown for this example).
System programming: an introduction
C.5