ESI IP 200 Installation Manual page 38

Function 2: CO lines
To allow for maximum flexibility, the DLC will allow you to select E&M without DID/DNIS outputs.
This is not a typical application, but can be supported with the understanding that E&M doesn't
ring. Therefore, route the answer ring assignments to an ID branch to be answered by the auto
attendant, because no routing digits will come into the translation table. We recommend loop or
ground start trunks for this application.
Channels that are programmed as E&M DID/DNIS can receive ANI (Automatic Number Identifica-
tion service; it provides the phone number of only the party calling in). This is supported on only
E&M DID/DNIS channels and must be provided by the carrier. If the carrier can provide ANI, it
needs to send this string: "*ANI*DID or DNIS*." This will enable the system to display the ANI on
the LCD of each Digital Feature Phone and route the call according to the DID/DNIS routing table.
Note: Not all carriers can support this function.
After the E&M programming is complete, select the outbound CO line groups and assign the ID
branch to answer.
To complete the programming of the E&M trunks selected:
1. Use the scroll keys to select the outgoing signal type — WINK START, IMMEDIATE START or DIAL
TONE START. Press # to confirm. Default is WINK START.
OUTGOING SIGNAL
DIAL TONE START>
2. Use the scroll keys to select the incoming signal type — either WINK START or
IMMEDIATE START. Press # to confirm. Default is WINK START.
INCOMING SIGNAL
IMMEDIATE START>
3. Use the scroll keys to select the trunk mode — 2-WAY TRAFFIC, INBOUND ONLY or OUTBOUND
ONLY. Press # to confirm. Default is 2-WAY TRAFFIC.
TRUNK MODE
2-WAY TRAFFIC
4. Use the scroll keys to set dial tone transmit to either OFF or ON. Press # to confirm.
Default is OFF.
DIAL TONE TRANS.
OFF
5. Use the scroll keys to set ringback transmission to either OFF or ON. Press # to confirm. Default
is OFF.
RINGBACK TRANS.
OFF
Outbound CO line groups
Select the line group — 9, 8, 71, 72, 73, 74, 75 or 76 — and press # to confirm. Outgoing calls will
be assigned from the highest CO to the lowest available. Default is 9. (You can designate a private
line by entering an extension number instead of a line group in this step or 0 for incoming-only line.)
Answer ring assignment
Lines can be programmed with four different ring assignments — Ring 1, Ring 3, Ring 5 and Ring 9.
Each ring count can be programmed for up to 10 extensions, a department, a mailbox or an auto
attendant branch ID. After all lines are programmed for day mode, the system prompts for only the
answer ring assignment step for night mode.
E.6
>
>
>
IP Series Installation Manual