ESI IP 200 Installation Manual page 37

IP Series Installation Manual
Answer ring assignment
Lines can be programmed with 4 different ring assignments, Ring 1, Ring 3, Ring 5 and Ring 9. Each
Ring count can be programmed for up to 10 extensions, a department, a mailbox or an auto atten-
dant branch ID. After all lines are programmed for day mode, the steps are repeated for night mode.
After the COs are programmed, the LED will glow amber.
Function 212: T1 programming (DLC)
This function allows you to program the trunks and line parameters for the DLC. The system will
identify the number of DLCs installed (one or two cards) and allow you to scroll through the 24
channels on each port card.
T1 PROGRAMMING
Note: If two cards are used in a single system, the first card will sync with the network and become
the source clock for the system. For best results, any fax or modem devices on analog ports
should use lines from the first card.
Function 2121: CO line programming
Software has identified the port card type installed as a DLC configured for T1. The display will show
the following information: the first line will show the port card number, the type of card, the COs
available to program and a D or N for day or night mode. The second line will show the CO currently
selected and the circuit that is being programmed. If multiple COs are selected, then the last CO
selected is displayed. All DSS LEDs will glow red until selected for programming.
You can select from the first set of 16 COs, and then press the scroll key to select from the remain-
ing eight CO lines on the first port card. Scrolling again will allow you to select the 16 COs on
a second port card if one is installed, and scrolling again will allow you to select from the
eight remaining COs. If there is only one port card installed, then scrolling will return you to
the first 16 COs. Select the COs to program alike and press # to confirm. The LED will glow green
and then, after a CO is programmed, the LED will glow amber. After the selected COs are pro-
grammed, the LED will glow amber.
For example: if the port card in the third slot is a DLC configured for T1, the display will be:
PC3 T1 13-36 D
CO22 CIRCUIT 10>
Enter the CO line name (for more details, see "Naming the CO lines," page E.2.) and then press #
to confirm.
Use the scroll keys to select the trunk type emulation: either E&M DNIS/DID, E&M, LOOP START or
GROUND START. Press # to confirm. (Default is E&M DNIS/DID.)
TRUNK EMULATION
E&M DNIS/DID
If LOOP START or GROUND START is selected:
Continue with the outbound CO line groups and answer ring assignment.
If E&M DNIS/DID is selected:
The lines are routed to the DNIS/DID table (programmed in Function 224). After the E&M program-
ming is complete, select the outbound CO line groups.
If E&M is selected:
The lines are routed to the answer ring assignment.
>
Function 2: CO lines
E.5