Eagleeye Producer Auto Calibration; View System Status; Configure The Polycom Eagleeye Director - Polycom realpresence group series Administrator's Manual

EagleEye Producer Auto Calibration

You can configure the EagleEye Producer to automatically calibrate its integrated camera and an attached
EagleEye IV camera. This is important when the cameras are projecting images that are not aligned.
To enable auto calibration:
1 Attach the EagleEye camera to the EagleEye Producer, as shown in Setting Up the Polycom
EagleEye Producer.
2 Ensure that camera tracking is enabled, as described in
In the web interface, go to Admin Settings > Audio/Video > Video Inputs > Input [input
number], and select the Automatic Image Calibration checkbox.

View System Status

To view the system status of an EagleEye Producer, do one of the following:
● In the local interface of the RealPresence Group Series system, go to Settings> System
Information> Status.
● In the web interface of the RealPresence Group Series system, go to Diagnostics > System >
System Status.
If a Polycom EagleEye Producer is connected, the connection status displays. If the camera is not
connected or is not selected as the current camera source, this choice is not visible on the screen.
To view more information about Polycom EagleEye Producer, select More Info.
For more information about using EagleEye Producer, refer to the Polycom EagleEye Producer User Guide
on support.polycom.com.

Configure the Polycom EagleEye Director

Use the remote control or web interface to configure the Polycom EagleEye Director. You cannot configure
the EagleEye Director using the Polycom Touch Control, but you can start and stop camera tracking.
For setup instructions, refer to Setting up the Polycom EagleEye Director on support.polycom.com.
After setting up the EagleEye Director, follow these steps to get started:
1 Power on the EagleEye Director.
You can verify that the device is detected and compatible with the RealPresence Group system's
software on the System Status page. Do one of the following:
 In the local interface, go to Settings > System Information > Status > EagleEye Director.
 In the web interface, go to Diagnostics > System > System Status > EagleEye Director.
As long as you see EagleEye Director among the status settings, the device has been detected.
2 Calibrate the cameras. Refer to
notice that the speaker is not framed accurately, ensure that the vertical bar of the EagleEye
Director is vertical. Placing the EagleEye Director on a horizontal surface can help to ensure that the
vertical bar is vertical. You might also need to recalibrate the cameras.
3 Adjust the room view. Refer to
Polycom, Inc.
Calibrate the EagleEye Director Cameras
Adjust the Room View
Stop and Start Camera
for instructions. If you
for instructions.
Monitors and Cameras
Tracking.
82