Configure The Polycom Touch Control Lan Properties - Polycom realpresence group series Administrator's Manual

Setting
EAP/802.1X Identity
(under EAP 802.1X in
local interface)
EAP/802.1X
Password
(under EAP 802.1X in
local interface)
Enable 802.1p/Q
(under 802.1p/Q in
local interface)
VLAN ID
Video Priority
Audio Priority
Control Priority

Configure the Polycom Touch Control LAN Properties

Before you can use the Polycom Touch Control with the RealPresence Group system, you must configure
the LAN settings.
To configure Polycom Touch Control LAN settings:
1 From the Home screen, touch
2 Touch the LAN Properties tab.
3 Configure the following IP Address (IPv4) settings.
Polycom, Inc.
Description
Specifies the system's identity used for 802.1X authentication. This setting is available
only when EAP/802.1X is enabled. The field cannot be blank.
Specifies the system's password used for 802.1X authentication. This setting is required
when EAP-MD5, EAP-PEAPv0 or EAP-TTLS is used.
Specifies whether VLAN and link layer priorities are enabled.
Specifies the identification of the Virtual LAN.This setting is available only when 802.1p/Q
is enabled. The value can be any number from 1 to 4094.
Sets the link layer priority of video traffic on the LAN. Video traffic is any RTP traffic
consisting of video data and any associated RTCP traffic. This setting is available only
when 802.1p/Q is enabled. The value can be any number from 0 to 7, although 6 and 7
are not recommended.
Sets the priority of audio traffic on the LAN. Audio traffic is any RTP traffic consisting of
audio data and any associated RTCP traffic. This setting is available only when 802.1p/Q
is enabled. The value can be any number from 0 to 7, although 6 and 7 are not
recommended.
Sets the priority of control traffic on the LAN. Control traffic is any traffic consisting of
control information associated with a call:
• H.323—H.225.0 Call Signaling, H.225.0 RAS, H.245, Far End Camera Control (FECC,
which, for RealPresence Group systems, is the Allow Other Participants in a Call to
Control Your Camera setting under Admin Settings > Audio/Video > Video Inputs
> General Camera Settings)
• SIP—SIP Signaling, FECC, Binary Floor Control Protocol (BFCP)
This setting is available only when 802.1p/Q is enabled. The value can be any number
from 0 to 7, although 6 and 7 are not recommended.
Administration.
Networks
44