LED
Alternate Amber and Blue
Blinking Amber
Green
Blinking Green
Fast Blinking Red
Blink
Connect and Power On the Polycom
™
Touch
This section describes how you can make connections so that you can power on, power off, and wake up
®
the Polycom
RealPresence Touch™. For information about enabling and setting the RealPresence Touch,
refer to
Enable and Set Up the RealPresence
Connect and Power On the RealPresence Touch
Before you can power on the RealPresence Touch, you must connect the Ethernet cable to the device.
To connect and power on the RealPresence Touch:
1 Connect the Ethernet cable to the back of the RealPresence Touch device.
2 Plug the Ethernet cable into the wall outlet. Do one of the following:
If your room provides Power Over Ethernet, you can connect the Ethernet cable directly to a LAN
outlet.
If your room does not provide Power Over Ethernet, you must connect the Ethernet cable to the
optional power supply adapter. Then connect the power supply adapter to a LAN outlet and power
outlet. The power supply adapter is sold separately.
The RealPresence Touch powers on and displays the language selection screen in the setup wizard.
Power Off the RealPresence Touch
If you need to move your RealPresence Touch device to another area, power off the device before you
disconnect the Ethernet cable.
To power off the RealPresence Touch:
1 On any screen, tap
2 Sign in using your Admin ID and password.
3 Scroll down to Power and Pairing.
4 Touch RealPresence Touch Power until a Shutting down... message displays.
The RealPresence Touch is powered off.
Polycom, Inc.
Introducing the Polycom RealPresence Group Series Systems
System State
Software update, Factory restore, USB image update
USB disk plugged in
On, In a call
On, In a call, Receive IR in a call
System error
Needs attention, Receive IR
Touch.
Menu, Settings, and then Administration.
®
RealPresence
30
Need help?
Do you have a question about the realpresence group series and is the answer not in the manual?
Questions and answers