Advertisement
23(5$7,21
0LUDJH
The number shown here indicates how many watts are applied to the lamp.
32:(5
Set from 350-500 watts (Mirage 2000) or 800-1200W (Mirage 5000) as desired.
Keep in mind that lower power levels produce dimmer images. When in "
0D[ %ULJKWQHVV
the power level will change as necessary. Specifying the maximum power level in
mode is the same as operating in
3RZHU
NOTES: 1) Power level can be set only if the lamp is in "power" mode. 2) If you are
in "Intensity" mode, the power level value will automatically increase over time as
necessary to closely maintain the desired brightness, until power reaches its
maximum.
,17(16,7< ²
decreasing over time when you are operating at
level. However, when you are operating in "
original "
,QWHQVLW\
NOTE: The number shown for "intensity" is not the actual lumen output, but rather a
correlated value only—9999 may represent up to 5000 lumens, for example.
To use "
,QWHQVLW\
application, remembering that higher settings can significantly shorten lamp life.
Over time, the projector will automatically increase the power supplied to the lamp as
needed to maintain the chosen intensity as closely as possible. This is called
"brightness tracking".
Keep in mind that once the lamp power has reached its maximum (see "
above), such tracking is no longer possible. At this point, the lamp will gradually
begin to dim as usual, even though your original "
the menu. To resume accurate tracking, reduce the intensity setting so that the
resulting "
can be maintained.
Do not set "
minimum (350 watts in Mirage 2000, 800 watts in Mirage 5000)—the intensity
setting cannot be maintained and will be inaccurate. For best results in achieving
fairly uniform intensity amongst tiled images, choose an "
enables all lamps to operate at less than the maximum number of watts available in
your projector but high enough to keep the corresponding lamp power above its
minimum. See "
NOTES: 1) Lamps become more stable over time, thus a specific intensity is more
easily maintained as the lamp ages. 2) Intensity can be set only if the lamp is in
"Intensity" mode 3) Intensity cannot exceed the output of Max Brightness mode.
/$03 +,6725<
recently installed and recorded in the projector. Lamp History
automatically updates whenever you record a new lamp serial
number—the new lamp is added to the bottom of the list.
8VHU·V 0DQXDO
modes, the power level remains constant. When in "
This number is a representation of the current brightness of your lamp,
" setting chosen.
" mode, judge by eye and set the level as desired for your
" value is under its maximum—the lower the intensity, the longer it
3RZHU
" so low that the corresponding "
,QWHQVLW\
", above.
3RZHU
This read-only option lists the most lamps most
mode.
0D[ %ULJKWQHVV
0D[ %ULJKWQHVV
" mode, this value remains at the
,QWHQVLW\
" value will still appear in
,QWHQVLW\
" value reaches its
3RZHU
,QWHQVLW\
" or
3RZHU
" mode,
,QWHQVLW\
or at a specific
3RZHU
",
3RZHU
" setting that
Advertisement
