Advertisement
0$,17(1$1&(
$% !
$% !
0LUDJH
/RRVHQ WKH VSULQJORDGHG 7EROWV
N
The lamp module is secured
to its adjustment plate with 3
large spring-loaded T-bolts
that lock in-and-out with a
90° turn (they are the largest
heads visible on the
adjustment plate). To remove
each T-bolt, use a Phillips
screwdriver to push and
turn each bolt 90°. The pin
behind each bolt will align
with its slot and pop the bolt
free. See right. NOTE: If you
can't access the bottom
screw in the 5000, decrease
vertical offset.
5HPRYH ODPS DQG GHWDFK IURP WHUPLQDO EORFN
N
Pull the lamp module out slightly. Note that it is still attached to a "terminal
block" which connects to the lamp power supply via anode and cathode
cables–the lamp module cannot be fully removed yet.
N
Remove the single screw securing the lamp module to the terminal block. See
Figure 4.5. The lamp should now be fully free–refer to the recycling/disposal
instructions provided with the new lamp kit.
8VHU·V 0DQXDO
)LJXUH 'HWDFK ODPS IURP WHUPLQDO EORFN 723 9,(:
,03257$17
'HWDFK WKH ODPS IURP WKH WHUPLQDO EORFN RQO\
'R QRW GLVFRQQHFW FDEOHV
)LJXUH /RRVHQ VSULQJORDGHG 7EROWV
6+2:1 25,(17$7,21 5(9(56( )25
Advertisement
