Advertisement
23(5$7,21
0LUDJH
N
N
N
N
N
&RORU
&RORU
&RORU
Press
image. Lower settings produce less saturated colors — a setting of "0" produces a
black and white image, for example. If the color level is too high, colors will be
overpowering and unrealistic. Use
level is displayed. The
7LQW
7LQW
Press
7LQW
signals or HDTV signals. For best results, adjust tint while displaying a proper
external test pattern from the source — otherwise, it is recommended that tint remain
at its default setting. Use
'HWDLO
'HWDLO
Press
'HWDLO
video). Use
that any level of detail above 3 will also introduce a certain degree of noise in the
image. Set below 3 to filter the signal and remove noise from a noisy source.
&RQWUDVW
&RQW
Press
&RQW
reach the desired level of contrast—for best results, start low and increase so that
whites remain bright but are not distorted or tinted, and that light areas do not
become white (i.e., are "crushed"). Conversely, low contrast causes dim images. See
3.6, Adjusting the Image (Image Settings subsection).
%ULJKWQHVV
%ULJKW
Press
%ULJKW
until you reach the desired level of contrast—for best results, start high and
decrease so that dark areas do not become black (i.e., are "crushed"). Conversely,
high brightness changes black to dark gray, causing washed-out images. See 3.6,
Adjusting the Image (Image Settings subsection).
9ROXPH
9RO
Non-functional.
3URMHFWRU
3URM
Press
3URM
simply need to see if the local projector is listening. The number appearing in the
"Enter Number" window indicates which projector is currently listening to
8VHU·V 0DQXDO
6KXWWHU
+
21
= close the shutter
6KXWWHU
+
2))
= open the shutter
6WE\
+
21
= put the projector in standby mode
6WE\
+
2))
= leave standby
3RZHU
21
+
= turn the projector on
3RZHU
+
2))
= turn the projector off
0XWH
+
21
= hide the current menu
0XWH
+
2))
= show the current menu
26'
21
+
= turn the menu system on
26'
+
2))
= turn the menu system off
to adjust the color saturation level, i.e. the amount of color in a video
&RORU
key has no effect when the ADP option is used.
to adjust the red/green color hue for true color reproduction of NTSC video
and
to adjust the sharpness of a video image (it is of limited use for non-
and
until the display is as sharp as desired, keeping in mind
to change the amount of white in your images. Use
to increase or decrease the amount of black in the image. Use
when you want to access a specific projector within a network or if you
(OPTIONAL)
(OPTIONAL)
and
until the desired color saturation
until the desired tint is displayed.
and
until you
and
Advertisement
