Advertisement
6HULDO3RUW
&RQQH.WLRQV
,I XVLQJ D FRPSXWHU
"incremental" fine-tuning only if the direction of lens movement has not
changed during an adjustment. See Figure 2.22.
Alternatively, simply enter a new position to reverse direction. For example, if
the current setting is 2000, enter 2001 to start moving up—then press
current setting is 2001, enter 2000 to start moving down—then press
N
When adjusting lens offsets, slidebar values will not reach extremes of 0 or
9999. This is normal and does not mean that corresponding lens mount
movements failed to reach their physical extremes.
NOTE: Communication software is required for serial control. Contact your dealer
for details.
You may wish to use equipment other than the keypad for controlling the projector or
for performing other special functions. Such equipment—such as most personal
computers—requires a serial interface for sending and receiving communications
through the serial ports on the projector. Note that there are two different types of
serial communication ports on this projector as described below.
56 3RUWV
From most computers, connect an
computer and the projector serial port labeled
is located near the bottom center of the projector's rear control panel (see Figure
2.23). Then set the projector baud rate to match that of the computer (changing the
baud rate is described in 3.7, Adjusting System Parameters and Advanced Controls).
NOTE: Refer to Appendix D for complete cable wiring details.
)LJXUH 56 6HULDO &RQQHFWLRQ WR D &RPSXWHU
/HQV 6HWWLQJV DQG WKH ,/6
)LJXUH
serial communication cable between the
56
,167$//$7,21 6(783
%
—this 9-pin D connector port
56 ,1
8VHU·V 0DQXDO
0LUDJH
. If
.
Advertisement
