,167$//$7,21 $1' 6(783
&RQYHUWLQJ D .H\SDG
0LUDJH
If desired, you can convert an IR remote keypad into a wired remote keypad and vice
versa (available February 2000).
72 &+$1*( )520 ,1)5$5(' 72 :,5('
N
N
N
N
N
N
N
72 &+$1*( )520 :,5(' 72 ,1)5$5('
N
N
N
N
N
N
8VHU·V 0DQXDO
Remove battery compartment cover from back of keypad.
Remove batteries.
Wait 1-2 minutes.
Plug the keypad cable (available separately) into the empty battery
compartment. Make sure that the battery cover is notched smoothly to
accommodate the cable.
Set keypad protocol as desired, using "wired" jumper settings.
Replace battery compartment cover.
Plug into the 3-pin XLR port at the rear panel of the projector.
Unplug the keypad from the projector.
Open the keypad back and unplug the keypad cable.
Wait 1-2 minutes.
Install batteries (see Section 4).
Set keypad protocol as desired, using "IR" jumper settings.
Replace battery compartment cover.