Advertisement
This section explains how to install and set up your projector. If you are familiar with the projector and want to
quickly set it up for temporary use, follow the Quick Setup instructions below. For a more complete setup, follow the
instructions and guides covered in the remaining subsections.
NOTES: 1) The lens is not installed for shipping. For instructions on how to install or replace a lens, refer to 4.5,
Replacing the Lens. 2) This section assumes that the optional video decoder module is installed.
4XL.N6HWXS
67(3
67(3
67(3
67(3
67(3
,QVWDOODWLRQ 6HWXS
Follow these steps for quick setup of the projector in a standard floor mount position.
3RVLWLRQ WKH 3URMHFWRU
Set the projector at the expected throw distance (projector-to-screen distance) and
vertical position. See 2.3, Projector Position and Mounting and Appendix E. Make
sure that the projector is level from side-to-side (see 2.7, Leveling) and lens cap is off.
&RQQHFW D 6RXUFH
Locate the main input panel at the rear of the projector. The lower left area, labeled
,1387
, accepts an RGB input via BNC connectors. The upper right area (assuming
a video decoder is installed) accepts a composite video at
,1387
. Connect your source to the appropriate panel connectors.
&RQQHFW WKH /LQH &RUG WR $& 3RZHU
Connect the projector's line cord to the AC receptacle at the lower right rear corner of the
projector and to proper AC. The Mirage 2000 requires input power of 100-240 VAC, 50-
60 Hz @ 9 amps (@ 100 V). The Mirage 5000 requires input power of 200-240 VAC, 50-
60 Hz @ 8.5 amps (@ 200 V). Use the line cord provided with the projector. See Section 5.
'R QRW DWWHPSW RSHUDWLRQ LI WKH $& VXSSO\ DQG FRUG DUH QRW
ZLWKLQ WKH VSHFLILHG YROWDJH DQG SRZHU UDQJH 6HH 6HFWLRQ
7XUQ WKH 3URMHFWRU 21
Using either the built-in or remote keypad, press
second to turn the projector on (or press
about five minutes. The
input panel, should glow a steady green.
6HOHFW D 6RXUFH
Using either the built-in or remote keypad, press
and display the image for the source you connected in Step 2. The display will resize
as needed, producing an image as large as possible for the type of source present.
:$51,1*
3RZHU
32:(5
LED, located in the lower right corner of the rear
6 H . W L R Q
,1387
or S-video input at
3RZHU
and hold for approximately 1
21
). Let the projector warm up for
,QSXW
,QSXW
,QSXW
,QSXW
,
,
, or
8VHU·V 0DQXDO
0LUDJH
to select
Advertisement
