Advertisement
(UURU
&RQGLWLRQV
8VHU (UURUV
,QSXW 6LJQDO (UURUV
6WHS 5HDGMXVW &RORU 7HPSHUDWXUH OHYHO RI UHGJUHHQEOXH LQ =RQHV
Return to Steps
D
still exhibit a single color temperature.
&DQFHOLQJ %ULJKWQHVV 8QLIRUPLW\
If you do not want to use or apply Brightness Uniformity settings, delete the
checkmark from the "Uniformity Enable" checkbox at the top of the Brightness
Uniformity menu.
Occasionally the projector may encounter an error condition that interrupts normal
operation. Such a condition can be caused by an invalid user entry, an input signal
error (most common) or other system error.
If you would like to be notified on-screen of such errors, select the "Screen" option
from the "Display Error Messages" pull-down list (in Preferences menu). If you
would like to be notified via a serial communication only, select the "RS-232" option
instead. To receive both notifications, select "All". To disable error messages (except
for invalid user entries), select "Off".
NOTE: Error messages also always appear at the rear LCD next to the keypad.
,QYDOLG 8VHU (QWU\
Any keypad entry not recognized by the projector will trigger an on-screen error
message describing the problem. For example, if you specify a channel number that
has not been defined, the message "Invalid Channel will appear. Or if you try to enter
the wrong password, you'll see "Invalid Password". Press
message and eliminate the message box.
NOTE: Displaying of "Invalid User Entry" messages cannot be disabled, even if
Display Error Messages has been set to "Off".
Input signal errors messages appear when you are in presentation level (i.e., when
there are no menus present) and have selected an input on which the projector detects
a problem. While menus remain operational and pressing any key will temporarily
remove the message from the screen, you must resolve the signal problem in order to
permanently eliminate the message.
NOTE: Input signal messages appear on-screen only if Display Error Messages has
been set to "Screen" or "All".
1R 6LJQDO
The message "No signal" appears when there is no signal detected at the selected
input. Both HSYNC and VSYNC are inactive and the screen background is black.
Connect or correct the signal, or select another input.
%DG 6\QF
The message "Bad Sync" is displayed when HSYNC or VSYNC are active but the
signal cannot be displayed. Such a condition occurs when only one of the two signals
is present, or when either signal is unstable or of the wrong frequency. Correct the
signal or select another input.
&
and, if necessary, fine tune the zones so that they all
D
E
23(5$7,21
(QWHU
([LW
or
to confirm the
8VHU·V 0DQXDO
0LUDJH
Advertisement
