Advertisement
30 seconds to complete, make sure the focus motor is engaged as described in 4.5,
Replacing the Lens.
&(17(5 /(16
the lens to the approximate center of the lens opening—the image will be fairly well-
centered on this axis. Note that if centering remains significantly "off", lens mount
bore sight is likely poor. Contact your dealer for service.
6KXWWHU
6KXWWHU
237,21$/ )81&7,21
If your projector has a mechanical lens shutter (a.k.a. dowser) added, press and hold
6KXWWHU
for approximately 1 second to toggle the shutter closed or open with a single
key press (this also blanks the image electronically). Or quickly press and release
6KXWWHU
and follow immediately with
toggle (useful if you are unsure of the present status). Close the shutter whenever you
want to mute all display yet maintain access to projector functions. Open the shutter
to regain the display. With no shutter installed,
electronically, but the blanking is not quite as black.
NOTES: 1) The status of the shutter is shown in the LCD window on the rear panel of
the projector. 2) Upon power-up, the shutter is open. 3) The lamp remains on.
0XWH
0XWH
0XWH
temporarily turns the current menu on or off—press and hold
approximately 1 second to toggle with a single key press. Or quickly press and
0XWH
release
and follow immediately with
correct toggle (useful if you are unsure of the present status). With either method, a
small message appears on screen while the menu is muted.
)XQF
)XQFWLRQ .H\
From presentation level, press
color or colors in the display. For example,
data,
)XQF
shown below and also appears on the back of the IR remote keypad. Color enabling
can also be accessed through the menu system rather than these shortcuts.
NOTE: Once
)XQF
non-numeric entry until 2 digits have been entered or until 5 seconds of inactivity
have elapsed.
)XQF
Use of the
elsewhere in Section 3. For example, press
deletion or copying of a channel.
This option removes most vertical and horizontal offset and returns
21
)XQF
followed by a 2-digit number to enable a specific
will display all colors data. The list of available color combinations is
)XQF
= Red
)XQF
= Green
)XQF
= Blue
)XQF
= Red and Green
)XQF
= Green and Blue
)XQF
= Red and Blue
)XQF
= All colors (
is pressed in presentation level, the projector will not respond to
key within the menu system is noted with the appropriate topic
or
2))
if you want to guarantee the correct
6KXWWHU
still blanks the image
21
2))
or
if you want to guarantee the
)XQF
will display only red and green
([LW
does the same thing)
)XQF
in the Channel Setup menu to enable
0LUDJH
23(5$7,21
0XWH
for
8VHU·V 0DQXDO
Advertisement
