Advertisement
)RFXV
/HQV 2IIVHW
,QWHOOLJHQW /HQV 6\VWHP
,/6
12102725,=('
sharp as possible.
Press
02725,=('
desired with
NOTES: 1) Initially, your image may be so blurry you cannot recognize the "Focus"
menu option. Remember that
press
or
sight is likely poor. Contact your dealer for service.
Lens offsets move the lens and image. Try to achieve the desired overall image
position and best brightness while maintaining a rectangular image. If the brightness
looks uneven, or the edges do not look perfectly straight, the projector may not be in
the optimal position for your screen. See 2.3, Projector Position and Mounting for
full details. Lens offset ranges are also listed on page 5-1.
12102725,=('
adjacent to the lens. The top knob "Vertical" will raise or lower the image, the
bottom knob "Horizontal" will shift the image left or right.
Press
02725,=('
option (
or
Figure 2.1.
Other display adjustments are available through keypad commands and on-screen
menus—refer to Section 3, Operation.
%
NOTE: Requires motorized lens, available as an upgrade for Mirage 2000/5000.
%
Once you've defined lens settings for the current display, you can automatically
recall these positions whenever you use this channel. This Intelligent Lens System
(ILS
) function is particularly useful if you are working with a variety of source
TM
types that may differ in size and/or aspect ratio, since the custom lens settings you've
chosen for any channel will be quickly and accurately applied whenever you use that
channel.
%
(1$%/,1*
,/6
option (highlight it and press
horizontal and vertical offset—to the current channel settings recorded in projector
memory (see 3.5, Using Inputs and Channels if you are unfamiliar with channels).
The lens will then automatically reposition itself according to these lens settings each
time you use this channel. The ILS
subsequently define for other channels will also be recalled whenever you use those
channels.
You can still change lens settings as usual when the ILS
recalled the next time you use the channel.
:$51,1*
.HHS ILQJHUV DZD\ IURP WKH OHQV RSHQLQJ ZKHQ
RSHUDWLQJ WKH PRWRUL]HG ]RRP IXQFWLRQ
Near the lens opening, turn the lens focus tab until the image is as
/HQV
to display the Lens Control menu. Adjust image clarity as
or
. Refer back to Figure 2.1.
/HQV
activates the "Focus" control (#1)—from here,
to adjust. 2) If focus is not uniform throughout the image, bore
To relocate the image, turn either or both of the front knobs
/HQV
to display the Lens Control menu. Select either lens offset
) and move the image as desired with
In the Lens Control menu, enable the "Intelligent Lens System"
(QWHU
). This will add the 4 lens positions—focus, zoom,
is a global function—any lens settings you
TM
,167$//$7,21 6(783
or
. Refer back to
is enabled. Changes will be
TM
8VHU·V 0DQXDO
0LUDJH
TM
Advertisement
