Advertisement
23(5$7,21
The Mirage 2000 requires input power of 100-240 VAC,
$& /,1( &25' ,1387
50-60 Hz @ 9 amps (@ 100 V). The Mirage 5000 requires input power of 200-240
VAC, 50-60 Hz @ 8.5 amps (@ 200 V). Use the line cord provided with the projector.
See Section 5.
:$51,1*
'R QRW DWWHPSW RSHUDWLRQ LI WKH $& VXSSO\ LV QRW ZLWKLQ WKH
VSHFLILHG YROWDJH DQG SRZHU UDQJH 8VH WKH VSHFLILHG OLQH FRUG
Two LEDs (light emitting diodes) located in the lower right
67$78632:(5 /('6
corner of the rear connector panel indicate projector "Status" (top) and "Power"
(bottom). During normal operation, the "Power" light is steady green and the "Status"
light flashes green each time a key is pressed or when the projector receives a serial
command. Use the following as a guide:
)LJXUH 5HDGLQJ WKH 6WDWXV /('V
NOTE: A steady red power light accompanied by a coded pattern of red and yellow
flashes from the status light indicates an internal system error. Consult the rear LCD
display for an explanation, and see 3.10, Error Conditions. Should the problem
persist, contact a qualified service technician available through your dealer.
For optional tethered remote
5(027( :,5(' .(<3$' &211(&725 SLQ ;/5
control of the projector.
Alternative location for entering commands. NOTE: If desired, the
%8,/7,1 .(<3$'
keypad can be inverted by a qualified service technician. Contact your dealer.
Visual feedback for monitoring projector activities and status.
/&' 67$786 ',63/$< ²
The infrared (IR) sensors on the front and rear of the projector
,1)5$5(' 6(16256
receive infrared signals from the IR keypad for remote control of projector functions.
For proper operation make sure that these sensors are not blocked.
Emergency access for powering down the projector in the event of a
+$5' 5(6(7
system failure. Insert a pen point or small screwdriver.
8VHU·V 0DQXDO
0LUDJH
Advertisement
