Advertisement
23(5$7,21
0LUDJH
amount of vertical filtering according to the current source, and is the
recommended setting for most situations. You can override this by selecting a
value from 1-10, with "1" applying no filtering and "10" applying maximum
filtering. High filtering levels will soften the image slightly, particularly
evident along horizontal edges.
NOTES: 1) The Advanced 10-bit (ADP) submenu is available only if the optional
Advanced Digital Processing module has been installed in your projector. 2) The
ADP module is optimized for use with digital inputs, such as the Serial Digital Input
Module or the Digital HDTV Input Module. Images from analog inputs (Input 1, 3
or 4) will also be noticeably improved, however these signals are first converted with
8-bit processing before routing through the ADP module.
,19(57 67(5(2 '
and useful only if you are using a Stereo3D
Interface Module—and related components—
to reverse the projector's 3D display of
left/right frames. Such a configuration replaces
the need for a separate TTL inverter as
described in 3.8, 3D Images.
With your sync, Z-screen and, if desired,
emitter connected as described in 3.8, 3D Images, enter a checkmark (default). This
will invert the sync signal so that left/right image data is seen by the intended eye,
producing proper perspective in the display. Delete the checkmark if you do not want
to invert the signal via your Stereo3D
NOTE: This option has no function unless the Stereo3D
installed and connected. By default, the checkbox is checked and the signal inverted.
/DPS
Whenever you install a new lamp in the
projector you need to access the Lamp
submenu and record the lamp serial number in
the projector's memory. You can also set
different Lamp submenu options such as
intensity (output) or power required. These
setups can be changed at any time.
NOTE: See 4.4, Replacing the Lamp and
Filter for complete instructions on installing a
new lamp in the projector.
From the Advanced menu, select the "Lamp"
option for access to the Lamp submenu, where all lamp functions and data appear.
Read-only information includes the number of hours logged on the lamp so far and
the serial number recorded for the installed lamp.
/$03 +2856
record a new lamp serial number, this value automatically resets to "0", where it
begins to log time for the new lamp. NOTE: Read-only. This information also
appears in the Status menu.
8VHU·V 0DQXDO
%
This option is enabled
²
TM
shows the number of hours logged on the current lamp. Whenever you
TM
Interface Module.
TM
module is properly
)LJXUH /DPS 6XEPHQX
Advertisement
