Advertisement
0$,17(1$1&(
/DPS DQG )LOWHU
5HSODFHPHQW
3RZHU &RUG
DQG $WWDFKPHQWV
9HQWLODWLRQ
0LUDJH
7KH ODPS LV XQGHU JUHDW SUHVVXUH ZKHQ KRW DQG PD\ H[SORGH
FDXVLQJ SHUVRQDO LQMXU\ DQGRU SURSHUW\ GDPDJH $OORZ WR FRRO
The arc lamp operates at a very high temperature and
pressure. Failure to allow the lamp to sufficiently cool prior to
handling could result in an explosion causing personal injury
and/or property damage. After turning the projector off it is
important that you wait at least five minutes before
unplugging it. This provides enough time for the internal lamp cooling fans to cool
the lamp and to automatically shut off. Cool completely before handling.
Replace the side filter every 1000 hours or sooner. If this filter is not
),/7(5
replaced, air flow may become restricted and cause the projector to overheat.
See 4.4, Replacing the Lamp and Filter for the complete replacement procedure.
Only use attachments or accessories recommended by Christie, such as the specific
power cord supplied. Use of other attachments or accessories with this projector may
result in the risk of fire, shock or personal injury.
8VH RQO\ WKH $& SRZHU FRUG VXSSOLHG 'R QRW DWWHPSW RSHUDWLRQ
LI WKH $& VXSSO\ DQG FRUG DUH QRW ZLWKLQ WKH VSHFLILHG YROWDJH
Do not allow anything to rest on the power cord. Locate the projector where the cord
cannot be abused by persons walking on it or objects rolling over it.
Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
The projector is equipped with a three wire plug having a third (grounding) pin. This
is a safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to have the outlet replaced. Do not defeat the safety purpose of the
grounding-type plug.
Before unplugging the power cord, make sure the internal
lamp cooling fans have shut off. The fans automatically shut
off when the projector has adequately cooled down.
Slots and openings in the projector provide ventilation. To
ensure reliable operation of the projector and to prevent overheating, these openings
must never be blocked or covered. The projector should never be placed near or over
a radiator or heat register. The projector should not be placed in an enclosure unless
proper ventilation is provided.
8VHU·V 0DQXDO
1HYHU DWWHPSW WR UHPRYH WKH ODPS KRXVLQJ GLUHFWO\ DIWHU XVH
8VH RQO\ ODPSV VXSSOLHG E\ &KULVWLH
8VH RQO\ ILOWHUV VXSSOLHG E\ &KULVWLH
DQG SRZHU UDQJH 6HH 6HFWLRQ
:$51,1*
FRPSOHWHO\
:$51,1*
:$51,1*
:$51,1*
Advertisement
