Advertisement
,167$//$7,21 $1' 6(783
0LUDJH
6WHS
Unlatch and open the empty battery compartment on the back of the keypad as shown
in Figure 2.31.
NOTE: A wired keypad opens as shown, but a cable passes through the battery
compartment cover.
6WHS
Find the 4 jumpers located along the latching side of the battery compartment. These
jumpers set the keypad protocol and other settings so that the keypad functions in a
certain manner.
6WHS 6HW WKH -XPSHUV
Set the jumpers as shown in Figure 2.32. Take care to refer to the correct part of the
drawing — IR or wired (optional). Use tweezers or needle-nose pliers to remove and
replace each jumper as necessary.
-
N
jumper: For either remote, set between pins 1 and 2 to set as Protocol "A".
Set between pins 2 and 3 to set as Protocol "B".
-
N
jumper: For either remote, set between pins 2 and 3 as shown; otherwise, the
projector will not respond correctly to keypad commands.
-
N
jumper: For the IR remote, make sure that the jumper is set between pins 2
and 3 as shown. For the wired remote, make sure that the jumper is set between
pins 1 and 2 as shown.
-
N
jumper: For the IR remote, make sure that the jumper is set between pins 1
and 2 as shown. For the wired remote, make sure that the jumper is set between
pins 2 and 3 as shown.
6WHS
Replace battery compartment cover. Plug into projector (wired keypad only) and test.
8VHU·V 0DQXDO
)LJXUH 2SHQLQJ WKH .H\SDG
Advertisement
