Advertisement
is the serial number recorded for the current lamp. When you install a new
/$03 61
lamp and enter its serial number, the number will appear here in the Lamp menu.
NOTE: Read-only.
Enter a checkmark for
/$03 0(66$*(
upon power-up that the lamp has reached the specified lamp limit and should be
replaced. Delete the checkmark if you do not want to see this warning—instead,
when your lamp expires, only the status information on the back of the projector will
provide the warning to replace the lamp.
NOTES: 1) It is recommended that the Lamp Message checkbox remain enabled. 2)
When a lamp warning message appears, press
message. The message will continued to appear upon power-up until you install a
new lamp.
Set
to the number of hours you expect to log on the current lamp before
/$03 /,0,7
replacing it. The recommended limit is 1000 hours.
NOTES: 1) If you change modes over the life of a lamp, the lamp limit you originally
expected may no longer be possible. 2) Turning the lamp on and off can reduce lamp
life significantly, as will other factors.
Set which
you want to use in order to control the
/$03 02'(
light output. Although there are exceptions, in most lamps, the
higher the light output or power setting, the shorter the life
span of the lamp.
Use the lamp mode that best suits your brightness needs. For
example, in a tiled application you may want to precisely match brightness levels
between adjacent images—choose
set each individual intensity setting as necessary (see "Intensity", below). Or you
may simply always need as much brightness as possible—choose
Lamp modes are described below:
N
The lamp will always burn as brightly as possible, driven by
0D[ %ULJKWQHVV
maximum power of either 500W (Mirage 2000) or 1200W (Mirage 5000).
Keep in mind that the "maximum brightness" for any lamp gradually
diminishes with age—images will become dimmer over time. Its current
output level (note: not in lumens) appears in the "
N
Brightness will remain close to a specified level for as long as
,QWHQVLW\
possible. Once you select this option, enter a number representing the intensity
level (brightness) you wish to maintain—the projector will automatically
adjust power as needed to maintain this intensity as closely as possible. Note
that the intensity value is a correlation only (0-9999), not actual lumens level.
See "
" below.
,QWHQVLW\
N
The power supplied to the lamp will remain at a desired watt level
3RZHU
throughout the life of the lamp. Once you select this option, enter the number
of watts representing the power level you wish to maintain. See "
below.
if you want to enable a warning message
to temporarily cancel the
for each projector, then judge by eye and
,QWHQVLW\
,QWHQVLW\
0LUDJH
23(5$7,21
)LJXUH
.
0D[ %ULJKWQHVV
" option.
"
3RZHU
8VHU·V 0DQXDO
Advertisement
