Advertisement
*DLQ RU 6FUHHQ *DLQ
+HOS 6FUHHQ
+RUL]RQWDO )UHTXHQF\
+RUL]RQWDO 2IIVHW
+RW 6SRW
,/6
,QSXW
,QSXW 6LJQDO
,QWHUIDFH
,QWHUODFH
.H\SDG
.H\VWRQH
/LQHDULW\
/LQH RI %HVW 9LHZLQJ
The ability of a screen to direct incident light to an audience. A flat matte white wall
has a gain of approximately 1. Screens with gain less than 1 attenuate incident light;
screens with gain more than 1 direct more incident light to the audience but have a
narrow viewing angle. For example: An image reflecting off a 10 gain screen appears
10 times brighter than it would if reflected off a matte white wall. Curved screens
usually have larger gain than flat screens.
A display of help information regarding the current task or presentation.
The frequency at which scan lines are generated, which varies amongst sources. Also
called horizontal scan rate or line rate.
The difference between the center of the projected image and the center of the
projector lens. For this projector, this value is expressed as the maximum percentage
of the image that can be projected to one side of the lens center without degrading the
image quality. Horizontal offset ranges can be affected by the type of lens in use, and
whether or not the image is offset vertically at the same time.
A circular area of a screen where the image appears brighter than elsewhere on the
screen. A hot spot appears along the line of sight and "moves" with the line of sight.
High gain screens and rear screens designed for slide or movie projection usually
have a hot spot.
%
The Intelligent Lens System
lens mount to automatically return to lens settings previously defined for a particular
channel.
A physical connection route for a source signal, described by a 2-digit number
representing 1) its switcher/projector location and 2) its slot in the switcher/projector.
Signal sent from a source device to the projector.
A device, such as the Serial Digital Input Module, that accepts an input signal for
display by the projector.
A method used by video tape players and some computers to double the vertical
resolution without increasing the horizontal line rate. If the resulting frame/field rate
is too low, the image may flicker depending on the image content.
A small push-button device for controlling most projector settings and operation. For
more information, refer to 3.3, Using the Keypad.
A distortion of the image which occurs when the top and bottom borders of the image
are unequal in length. Side borders both slant in or out, producing a "keyhole" shaped
image. It is caused when the screen and lens surface are not parallel.
The reproduction of the horizontal and vertical size of characters and/or shapes over
the entire screen.
When light from a projector is incident on a screen, the light reflects from the screen
such that the angle of reflection equals the angle of incidence. The Line of Best
Viewing is along the line of reflection.
describes the ability of projectors having a motorized
™
0LUDJH
*/266$5<
8VHU·V 0DQXDO
$
Advertisement
