Advertisement
commands, and will match the projector number that has been defined in its
Preferences menu.
The "Projector" checkbox (read-only) shows whether or not the projector physically
connected to a keypad is listening to commands from that keypad. A checkmark
means that connected projector is listening; if there is no checkmark, you are
communicating with a different projector.
To use a specific projector, enter the 3-digit number assigned to the projector you
want to use. Press
other than the one you are currently using, the checkmark will be deleted.
To broadcast to multiple projectors, press
projector number. Keypad commands will then affect all projectors present.
NOTES: 1) The "Broadcast Keys" option in the Communications menu must be
selected for only one (any) projector in a serial network. The keypad in use must be
OFF (disabled) for the remaining projectors. See 2.10. Keypad Protocols and
Conversion, and 3.7, Adjusting System Parameters and Advanced Controls.
3L[HO
3L[HO
3L[HO
Press
to access the pixel tracking and pixel phase double slidebar. Adjust pixel
tracking first: use
sampling clock to correct consistency of the image. For proper phase, use
2))
to increase or decrease pixel phase so that any shimmer disappears and the
image is stable throughout. See 3.6, Adjusting the Image (Size and Position
subsection) for a complete explanation of tracking and phase.
3RVLWLRQ
3RVLWLRQ
Press
3RVLWLRQ
to move the image using the double slidebar. At the slidebar, use
and
to move the image left or right, use
down.
/HQV
/HQV
237,21$/
NOTES: 1) Requires a motorized lens. In non-motorized projectors, adjust the lens
manually for proper focus, zoom and offsets as described on page 2-2. 2) For full
details regarding use of motorized lens functions, refer to 2.8, Zoom, Focus and
Lens Offset.
Press
/HQV
to access remote
motorized control of
horizontal/vertical offsets, focus
and zoom, and other related
functions in the Lens Control
menu. All slidebars can be
adjusted with
set with a specific value entered
from the keypad.
NOTE: Since the direction of lens
travel affects the final true position of the lens, setting a lens position (focus, zoom or
an offset) to a specific value may cause the lens to reverse its direction of travel,
depending on its starting point, so that it approaches the setting from the necessary
(QWHU
to select, press
([LW
and
to increase or decrease the frequency of the pixel
and
, or
)LJXUH /HQV &RQWURO 0HQX
to cancel. If you switch to a projector
3URM
3URM
and then
again without entering a
21
and
2))
to move the image up or
8VHU·V 0DQXDO
0LUDJH
23(5$7,21
21
and
/HQV
Advertisement
