Download Print this page

Christie Mirage 2000 User Manual page 23

Hide thumbs Also See for Mirage 2000:

Advertisement

&RQQHFWLQJ 0XOWLSOH
6ZLWFKHUV

3RZHU
&RQQH.WLRQ
NOTE: Make sure any Marquee Signal Switcher connected directly to the projector
is set as "Switcher #1". If it is not, unplug the switcher and turn the thumbwheel to
"1" before plugging back in and connecting to the projector and/or network.
)LJXUH  &RQQHFWLQJ D 0DUTXHH 6LJQDO 6ZLWFKHU
If you are using more than one Marquee Signal Switcher, daisy-chain the RS-232
switcher inputs/outputs together to form a complete network of inputs accessible
from the projector (you can network up to 9 switchers), and connect Switcher #1 to
the projector as shown in Figure 2.20. In addition, connect the RGB output from each
switcher to its matching slot on switcher #1–for example, connect the RGB output
from switcher #2 to slot #2 on switcher #1, and the RGB output from switcher #3 to
slot #3 on switcher #1. Note that slots used in this manner on switcher #1 are no
longer recognized as inputs to the projector–if you select a slot location that is
connected to another switcher's RGB output, the projector will display the "no input
signal" error message.
Plug the projector's high-current line cord into the line input socket located in the
lower right corner of the rear panel of the projector, then plug the 3-pronged end of
the line cord into a grounded AC outlet. Input voltage to Mirage 2000 must be 100-
240 VAC. Input voltage to Mirage 5000 must be 200-240 VAC. Use the proper
power source and the high-current rated line cord provided. See Section 5,
Specifications for all power requirements.
'R QRW DWWHPSW RSHUDWLRQ LI WKH $& VXSSO\ DQG FRUG DUH
QRW ZLWKLQ WKH VSHFLILHG YROWDJH DQG SRZHU UDQJH
Caution: Once the projector is turned off, the lamp cooling fans will continue to
run for approximately five minutes to ensure that the projector and lamp have
sufficiently cooled, at which point the fans will automatically shut off. To avoid
thermal stress to the lamp, do not unplug the line cord while the lamp cooling fans
are running—and do not unplug the projector in order to power down.
,167$//$7,21 6(783
:$51,1*
0LUDJH 
8VHU·V 0DQXDO


Advertisement

loading

This manual is also suitable for:

Mirage 5000