Advertisement
,5 5HPRWH
:LUHG 5HPRWH
³237,21$/³
*XLGH WR .H\SDGV
.H\SDG &RPPDQGV
3RZHU
The IR Remote Keypad controls the projector by way of wireless communications
from a battery-powered infrared (IR) transmitter. Use the IR remote keypad the same
way you would use a remote keypad supplied with a TV or VCR. When making key
presses, point the keypad either toward the screen or toward the front or rear of the
projector. One of two sensors on the projector will detect the signals and relay the
commands for internal processing.
The wired remote keypad connects to the 3-pin XLR jack via a 50 ft. cable. It is
recommended when:
N
the rear of the projector is inaccessible
N
the lighting conditions are unsuitable for proper IR transmission
N
you want to use a separate keypad for each projector in a group
NOTES: 1) For extra long distances and/or harsh environments, you may prefer to
use an optional remote Two-Way Controller to control the projector. For operating
details, please see the Two-Way Controller User's Manual included with this
accessory. 2) Old VistaGRAPHX "Roadie style" keypads can be used with this
)XQF
projector, but the
Keep in mind the following guidelines:
Press keys one-at-a-time; there are no simultaneous key presses required.
For any key having an "*" (
second in order to toggle the function with a single key press. For other keys (or
to use a "*" key in conjunction with
a mouse click is sufficient.
Press the "lightbulb key" to temporarily illuminate the backlight for the keys
without sending any other command.
,
,
21
other keys, release and press again to repeat an action. In a network, pause
between adjustments to ensure that the last projector can "keep up" with the
commands.
If you press a key while the projector is busy with another action, such as during
a power-up, the key press may not take effect.
When you turn on the projector it begins operating at presentation level, displaying
an image from the most recently used source signal. The projector temporarily leaves
presentation level whenever you use the keypad to work with control settings, display
menus, or on-line help. For example, pressing
menu — presentation level is no longer active, although the image still appears in the
background. Press
to presentation level.
Specific keypad commands are explained below:
3RZHU 212))
Press and hold for approximately 1 second to turn the projector on or off with a
single key press. Or press
guarantee the correct toggle (useful if you are unsure of the present status).
NOTES: 1) Whenever the projector is turned off, the lamp cooling fans remain on for
about five minutes to cool the lamp. 2) It is a good idea to avoid turning a projector
key codes listed on the back are different and do not apply.
3RZHU
, for example), hold the key for approximately 1
, and
2))
repeat their "arrow" actions when held down. For
0HQX
([LW
again (or
) to return or leave the menu system and return
3RZHU
followed immediately by
21
or
2))
), a momentary press similar to
0HQX
after startup displays the main
21
or
8VHU·V 0DQXDO
0LUDJH
23(5$7,21
2))
if you want to
Advertisement
