Advertisement
,167$//$7,21 $1' 6(783
2SHUDWLQJ
2ULHQWDWLRQ
/HYHOLQJ
=RRP)R.XV
/HQV2IIVHW
0LUDJH
The projector is set up at the factory for use in a front screen, floor mount orientation.
If your initial installation is ceiling mount or rear screen, displayed images may be
upside down and/or reversed. To correct, you must change the image orientation
from within the Preferences
menu (you may prefer to do
this before physically
installing the projector in its
final position/orientation).
In the Preferences menu,
highlight and select the
"Image Orientation" pull-
down list. Select from Rear,
Inverted Rear, Front or
Inverted Front according to
your intended installation.
See Section 3, Operation for
further information.
For most installations, the
lens surface of the projector
is parallel to the screen—this
prevents major keystoning of
the image (i.e., an image
with non-parallel sides). In
addition, the projector must
be kept level from side-to-
side in order for the lamp to
function safely. To make small corrections to the projector's level, rotate each leg as
necessary to raise or lower. For angled installations, see "Special Mounting" under
2.3, Projector Position and Mounting earlier in this section.
Once the projector is properly set up and producing an image, you are ready to make
quick lens adjustments. Refer to 3.3, Using the Keypad and 3.4, Navigating the
Menus if you are unfamiliar with using the keypad and menu system.
NOTE: A manual lens mount is standard on Mirage 2000/5000 projectors.
=RRP
12102725,=('
barrel to decrease or increase the size of the image at the current throw distance.
02725,=('
menu. Select the "Zoom" option ( ) and adjust image size as desired with
. Refer back to Figure 2.1.
8VHU·V 0DQXDO
If you have a zoom lens installed, turn the textured ring of the lens
If you have a zoom lens installed, press
)LJXUH $GMXVWLQJ WKH )HHW +HLJKW
/HQV
to display the Lens Control
or
Advertisement
