Advertisement
,1752'8&7,21
+RZ 7KH 3URMHFWRUV :RUN
&RPSRQHQWV
'LIIHUHQFH %HWZHHQ 0RGHOV
3XU.KDVH
5H.RUGDQG
6HUYL.LQJ
0LUDJH
Mirage 2000/5000 models accept data/graphics and video input signals for projection
on to front or rear flat screens. High brightness light is generated by an internal
Xenon arc lamp (500W in the Mirage 2000, 1200W in the Mirage 5000), then
modulated by three DMD (digital micromirror device) panels that provide digitized
red, green or blue color information. Light from the "on" pixels of each panel is
reflected, converged and then projected to the screen through a single front lens,
where all pixels are perfectly superimposed as a sharp full-color 2D or 3D image.
Mirage 2000/5000 models include an infrared (IR) remote keypad, line cord, a 9/64"
hex socket ball driver, and a User's Manual. Make sure that you have all these items,
and note that purchasers also receive a Warranty Registration Card–complete this
card and return it directly to the manufacturer as soon as possible.
The Mirage 2000 is the same projector as the Mirage 5000, but has a 500W lamp
rather than a 1200W lamp. This affects the brightness output and range of
adjustment.
Whether the projector is under warranty or the warranty has expired, Christie's
highly trained and extensive factory and dealer service network is always available to
quickly diagnose and correct projector malfunctions. Service manuals and updates
are available to service technicians for all projectors.
Should you encounter a problem with the projector and require assistance, contact your
dealer or Christie. In many cases, any necessary servicing can be performed on site. If you
have purchased the projector, fill out the information below and keep with your records.
'HDOHU 3KRQH 1XPEHU
3URMHFWRU 6HULDO 1XPEHU
,QVWDOODWLRQ 'DWH LI DSSOLFDEOH
* NOTE: The projector serial number is located on the projector's rear identification label
8VHU·V 0DQXDO
)LJXUH &RPSRQHQWV
3XUFKDVH 5HFRUG
'HDOHU
3XUFKDVH 'DWH
Advertisement
