Advertisement
,167$//$7,21 $1' 6(783
9LGHR /RRS 7KURXJK
0LUDJH
To loop a single incoming video signal input (connected at the video decoder)
through to another projector or display device, use the empty connector(s) adjacent to
this same input as described below.
&RPSRVLWH 9LGHR /RRS 7KURXJK
&211(&7,216
to
,1387
cable from whichever
of the next display device or projector. Continue this looping method for each
projector, using either the phono plug or the adjacent BNC as input into
then using the other connector as an output (i.e., loop through). Whether you use the
BNC or the phono plug as input or output depends on the type of cable you have on
hand and what type of connectors are on each end.
9,'(2 7(50,1$7,21
checked for the final projector only. All other projectors must have this option
unchecked in order for the signal to continue. For other types of display devices in
the chain, typically a "Hi-Z" switch position is needed.
8VHU·V 0DQXDO
See Figure 2.17. From your source, connect a composite video signal
using either the small phono plug or the adjacent BNC. Connect a second
connector is free to one of the composite video inputs
,1387
In the Preferences menu, make sure "Video Termination" is
)LJXUH
&RQQHFWLRQV IRU &RPSRVLWH 9LGHR /RRS 7KURXJK
,1387
Advertisement
