Overland Storage SnapServer Administrator's Manual page 225

SnapServer 7.0 Administrator's Guide
Drive Status LED
The LEDs are visible with the bezel either on or off. The following LED behavior can be
observed when the SnapServer is ON.
Drive Activity LED
Link LEDs (Ethernet 1 and Ethernet 2)
Status LED
10400317-001 10/2011
Device State
No Disk Drive in Bay
Normal Operation
Unit Identification Indicator
RAID in Degraded
†
Mode/Rebuilding
Failed
*When the Unit Identification Indicator is turned on, all drive LEDs and the status
LED flash amber.
†All member drives of a RAID flash green/amber when the RAID is degraded and
throughout the entire rebuild process when the RAID is being repaired with a new
drive.
Device State
Powered OFF / No Activity
Drive Activity
Device State
Powered OFF
Link Up (SnapServer Powered ON)
Link Down
Device State
Powered OFF
Unit Identification Indicator
Booting
Normal Operation
Shutting down
Maintenance Mode
* When the Unit Identification Indicator is turned on, all drive LEDs
and the status LED flash amber.
©2010-11 Overland Storage, Inc.
C – Troubleshooting SnapServers
LED State
Off
Solid green
*
amber
Flashing
Flashing green / amber
red
Solid
LED State
Off
Flashing green
LED State
Off
Solid green
Off
LED State
Off
*
amber
Flashing
Solid amber
green
Solid
green
Flashing
green amber
Flashing /
C-2