Overland Storage SnapServer Administrator's Manual page 221

SnapServer 7.0 Administrator's Guide
12. To implement the changes, enter the following command:
source /etc/profile
Install the EMC Networker Client
1. Connect to the SnapServer via SSH, and log in as admin, using your admin user
password.
NOTE: SSH v2 is required. If you fail to connect to the server, ensure that your SSH client is
2. You are placed into the CLI shell. However, a standard Linux shell must be used to
install the agent. To launch a shell, type the following command and press
osshell
3. To change to superuser, enter the following command, and press
su -
4. At the prompt, enter the admin user password, and press
5. Use the
cd /shares/SHARE1/agent
6. To unpackage the client files, enter the following commands:
tar xvfz nw_linux86.tar.gz
7. To install the NetWorker Agent rpm, enter the following command:
rpm -Uvh --nodeps --relocate=/usr/=/hd/vol_mnt[X]/NetWorker/usr/
lgtoclnt-x.x-x.i686.rpm
where vol_mnt[X] is the NetWorker installation target volume and x.x-x is the version
number.
8. To start the EMC NetWorker daemon, enter the following command at the console:
/etc/rc.d/init.d/networker start
The NetWorker client is now installed.
9. Close the SSH client, return to the Web Management Interface. To start the newly
installed backup agent, navigate to the Maintenance > Shutdown/Restart page, and
click Restart.
10. Delete the client files you copied to the SnapServer because they are no longer
needed.
11. To verify the success of the installation, use your backup management software to
configure and run a test backup.
Backup and Restore Operations with the EMC NetWorker Client
This section describes special procedures EMC NetWorker users must use in order to
perform backup and restore operations on the SnapServer.
Add the SnapServer as a Root User
For backup operations, NetWorker requires that the SnapServer be configured as a root
user. To add the SnapServer root user as one of the administrators, use the following
procedure:
1. Open the NetWorker Administrator application.
10400317-001 10/2011
configured to connect via SSH v2.
command to change to the directory in the share, for example:
cd
©2010-11 Overland Storage, Inc.
B – Backup Solutions
Enter:
:
Enter
.
Enter
B-12